Cumberland, ME (207) 829-3900 
Covering Central & Southern Maine


C wWHEREmberland, ME (207) 272-0272
Covering Maine, New Hamshire, Vermont & Massachusetts

Drafty Windows | When to replace windows | Rook Energy Solutions

window air leakage infrared imageThe majority of home owners still believe that replacing windows is the best way to lower energy bills and make a home more comfortable. In almost every scenario, this thought process is not entirely true!

If a window is not functioning properly (i.e. it will not open or close properly – it cannot be locked) than it should be replaced, but these are the only reasons we see fit. In order to explain this reasoning, see the photo above. Most air leakage that occurs via windows is actually from the window frame – this image shows hot summer air that is infiltrating the home through the window frame and seeping through the finished trim work surrounding the window. On a cold winter day a home owner could walk past this window and feel a draft, the first thing they may think is that they need a new window – after seeing this photo however, they would realize all they need to do is remove the trim work around the window and apply some expanding spray foam that costs less than $10 per can from your local hardware store. Once foamed around, they could replace or re-install the trim work and have a window that performs great!

An issue that may arise: removing trim around windows and doors can be difficult and expensive if it is not done by a professional (especially if it breaks during removal), but this cost will be much less than replacing all your windows – and it will give you improved results!

Tip: Spend the money on the expanding spray foam, it is phenomenal stuff. Make certain that you have more than one small area to foam though, the foam will harden in the plastic applicator tube before you have used all the foam (unless of course you are using a professional foaming gun). Most homes that have 1 window with air leakage around the window frame have many more like this. Remove the trim on all affected windows first and then spray foam!

Tip: Stuffing fiberglass insulation into the window/door frame will not stop air leakage. Air will always find a way through fiberglass!


insulating windows

So should I remove the old fiberglass insulation that's already in the window frames before I use the spray foam or leave it in there and add the spray foam?

It's always best to remove

It's always best to remove the fiberglass insulaiton first and then fill the void with canned spray foam - no need to install fiberglass back in once the foam has cured.


Reply to comment | Rook Energy Solutions | Cumberland, ME

My spouse and I stumbled over here from a different web address and thought I should check things out.
I like what I see so i am just following you. Look forward to
looking at your web page yet again.

Post new comment

The content of this field is kept private and will not be shown publicly.